Crf bog...

2001hondacr125 · #1 07-24-2008, 10:25 AM

Well guys i need some advice on this bog on a thumper...Well i timed my squirt and its squirting for 1 sec...I think its hitting the slide some when it squirts which aka causes the bog when u twist the trottle fast..my question is does turning the timing screw in or out make it squirt later? ive got the bog down to just alittle now..

2001hondacr125 · #2 07-24-2008, 01:39 PM

now dont u guys all reply at once now...

Silver_Fox · #3 07-24-2008, 02:54 PM

What screw are you refering to as the "timing screw"? The duration of squirt is determined by the leak jet.

2001hondacr125 · #4 07-25-2008, 02:38 PM

It says on the paper that came with my new accelerator pump cover to re-set the pump timing to 3/32 the screw inside the push in pull meganisem cover it controls the diaphram...

**crfjedi393** · #5 07-25-2008, 03:10 PM

Is this a 2006 carb by any chance? They are JUNK on the 250F's. Most of them required all kinds of work.

2001hondacr125 · #6 07-25-2008, 04:49 PM

No this is a 2007 CRF 150R

pjg351 · #7 07-27-2008, 06:40 AM

I was talking to a guy about these yesterday, there is a timing screw that adjusts the fuel timing squirt into the carb on the 150's, if it's hitting the slide then you will be getting a bog, i would try a quarter turn at a time and see what happens. Just keep note of where you started from so you can go back to it if you get it all wrong.

2001hondacr125 · #8 07-27-2008, 07:36 AM

Oh...hmmm i think i will try that also do you guys think this will work? [Only registered and activated users can see links. ] or do you think hes just tryin to rip people off?