cr250 main jet
Hello. I took the carb apart to clean it for the first time since bike started bogging at high rpm's. I noticed that i need a new float valve and that my main jet is labeled #633, slow jet is stock.
I was looking over my service manual and it seemed odd that i could not find #633 in there. Its a 02 cr250 stock carb, wiseco piston @67.5,boyesen reeds, fmf expansion and silencer. What MJ should i be running with these accessories?
thanks for any advice,
In looking at FMF's jetting guide are you sure you MJ is a 633?
Main Jet 380
Pilot Jet 32.5
Needle Position 3RD
Air Screw 1.5
This is what FMF recommends 0 - 1500 FT and with FMF pipe and silencer.
So that would be fairly close if you were looking for a starting point.
Thanks for the response Scott. I should have taught about checking fmf's site before
Yeah i'm sure it's 633, that's the numbers that i saw on the MJ. I'm just going to purchase a new float and stock MJ, see how that goes then.
|Similar Threads for: cr250 main jet|
|Thread||Thread Starter||Forum||Replies||Last Post|
|460 main||Shoei_391||2-Stroke Dirt Bikes - Yamaha||4||08-02-2007 01:04 PM|
|Main Jet||Shoei_391||General Discussion||7||05-28-2007 08:05 PM|
|03 125 Main Jet||Supermoto||2-Stroke Dirt Bikes - Honda||0||10-15-2005 09:40 AM|
|96' CR250 main jet?||Jackal||2-Stroke Dirt Bikes - Honda||1||09-06-2004 12:17 PM|
|96' CR250 main jet question...||Jackal||2-Stroke Dirt Bikes - Honda||24||01-23-2004 03:23 AM|