|
|
#1
07-23-2003, 11:40 AM
| |||
| |||
| 2003 yz250 gearing question Got the fork seal fixed. Now, I'm onto gearing. I ride mainly in the woods in southwestern PA. Tight trails with rocks and roots and mud, mostly. Anyway, I have to lower my final drive and I was wondering if anyone had any experience with either 14/52-53-54 or a 13/50 combination. 14/50 is stock and I don't want to go as far as 13/50, but I don't want to put a 52 or 53 on back and not notice any difference. Does anybody know what gearing the Yamaha factory guys run on the GNCC Circuit??? Thanks, in advace, for your opinions.  |
|
#3
09-02-2003, 06:20 PM
| ||||
| ||||
 2003 YZ 250 gearing I read an article on the WORCS and Hare and Hound riders that ride 2003 YZ 250's and they actually go DOWN on the rear sprocket to a 49 tooth, BUT they also go to a smaller 18" rear wheel and tire - of course, thier motors are tweaked |
|
#4
09-21-2003, 01:18 PM
| ||||
| ||||
| Re: 2003 yz250 gearing question Youll feel the 53 but probably not much on the 52. Start with the 53 and see where your at then go from there.. |
 |
|
| Thread Tools | |
| |
Similar Threads for: 2003 yz250 gearing question | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Yz250 Gearing | Moto man26 | 2-Stroke Dirt Bike Forums | 3 | 03-09-2008 12:02 PM |
| 2003 cr 250 gearing/ 1st gear bog | crtracy | 2-Stroke Dirt Bikes - Honda | 1 | 02-01-2008 08:50 PM |
| Gearing on YZ250? | camaro80r | 2-Stroke Dirt Bikes - Yamaha | 0 | 03-26-2007 08:08 PM |
| 2003 cr 250 gearing? | dsguru | 2-Stroke Dirt Bikes - Honda | 4 | 03-18-2004 04:59 PM |
| CRF gearing question. | yz250fridah | General Discussion | 1 | 02-09-2004 04:49 PM |
: 
