Clutch Problem

[YzRacer#53]

Ok today I take out my bike I warm it up and i fully engage the clutch (clutch lever is all the way down) and put it in 1st gear and jolts forward and stalls.

[splitfirekx125]

i think ur problem would be that u got groves in ur clutch basket or u got to much freeplay in ur cable u should have 1/8" at the most or yeah need some new fiber clutch plates or last but not least u got coolant into ur bottom end which would indicate bad water pump seal it is on 1 the four but i think i would say the first 1

[YzRacer#53]

I also have 80Wieght for the oil and I checked my coolant and thats still the same.

[Rockey]

Is this the 02 YZ125?

If the bike isnt warmed up this is normal.

[YzRacer#53]

well I have ran bake and forth today for 2 hours with the bike in the truck and let the bike idle for 4 minutes. maybe that's why so tommorrow I will drain out the 80W and put in 10-30 yamalube and let it warm up for 30minutes think that would do?

[FFRacing11x]

80wt synthetic is fine(I hope your not using 80wt hypoid). It is probably the basket is notched or out of adjustment. It is NOT normal for it to do as you describe if it isn't warmed up.

[YzRacer#53]

it's not warmed up as im sure of because i'd let it idle for 3 minutes. but I was also dricing back and forth to dealerships today for 2 hours. I'm going to put yamalube 10-30w in there now i'll tell you how it goes.

[YzRacer#53]

Thank You guys so much my bike runs like a new one now i put the 10-30w in there and it's great I just got back in from doing a lil riding on the streets this thing has some balls compared to the 100. thank you so much